DIY: Jeans Bracelet

WHAT TO DO WHEN IT'S SNOWING LIKE CRAZY:

Try this totally, fabulous, stunning, easy DIY-project!

And I personally think it's so cute!

I was thinking to combine it with someting like these grey ripped jeans and a nice white T-shirt....

I promise: It's really easy! Just follow the one-by-one steps!

And this is how it works:

1// First measure your wrist and add 1,5 cm. Cut out a piece of fabric that is about 4 cm of width.

2// Add glue to the inside of the piece of the fabric. I used "Gütermann" fabric glue. Works really good.
     Make sure every spot is at least a little bit covered! Now work fast before the glue has dried!


3// Cut out a piece of a fabric, wide  enough so your button will
     fit in the loop at the end. (If you're using stretch-jeans: glue the fabric smaller together.
     The buttonloop will get more loose, the more often you wear the bracelet.)
     Fold the ends upon each other and glue them together.

4// Glue the loop for the button to one end of the strip.

5// Fold the strip together and hold it for a few seconds. Make sure that the glue is dry before you continue.

6// Mark the place on the outside of the fabric where your button will sit and than sew it on.

Your bracelet is ready to wear!

     WITH L♥VE
                       Fleur.